Unconventional Longboard Constructed From Unmarried Slice Of Tree

Normally, skateboards and longboards are constituted of many laminated layers of picket. This provides them a delightful flex that produces a relaxed experience. On the other hand, it’s now not the one solution to do issues. [DesignCo] went for an unconventional design, the usage of a big slice out of a tree as a substitute.

The advantage of the usage of a piece of tree trunk for a board is that it has an excessively horny glance with all of the rings visual. To show it right into a board, it used to be first more or less minimize to form, sooner than being planed right down to a uniform thickness. Additional shaping used to be then accomplished with the usage of a flap wheel on an perspective grinder. The picket used to be completed with a number of coats of tung oil sooner than being given a last seal with matte lacquer. A cast metal tail used to be then ready to compare, formed with an great curve and with two bolts screwed in. Those bolts had been then epoxied into the board, becoming a member of the 2, and vehicles put in beneath.

The general construct seems to be surprising, and is ride-able too. It’s most probably a little bit slipperier than a board with grip tape, and it most definitely wouldn’t deal with bumps in addition to a conventional design. Lengthy forums are infrequently about efficiency anyway, even though, and this board looks as if nice a laugh to get round on.

We’ve noticed non-traditional longboards sooner than, too. Video after the wreck.

Previous PostNextNext Post